Auto lift machine manufacturers introduced the four wheel alignment instrument installation position method
2015/7/27 view:
Auto lift machine manufacturers introduced the four wheel alignment instrument installation position method:
The four sensor according to the corresponding positions of the wheels mounted to the fixture. To pay attention in the positioning of the sensor shaft to smear the dilute lubricating oil (butter), to prevent the plug for a long time after the positioning shaft wear and tear, cannot accurately installed in place that may affect the measurement accuracy. Connect the communication cable and the corner panel cable. Insert the arrow on the cable plug and the arrow on the socket. Four cables is the difference of different lengths, two 6.5 meters of cable is used to connect the sensor positioning system, and the two front wheels and two 4.5 meters of cable is connected with each other between the front and rear sensor. Each sensor has 3 sockets, the above two are exactly the same, the following one is used to connect the angle plate. When the cable is connected, the retaining pin is pulled off the corner plate and the back plate. Lock the vehicle would fall into a minimum lift stop position, to ensure the lifting platform in a horizontal state. Locator boot, sensor, power indicator light, press the R key or the position corresponding to the key activation of each sensor, the sensor placed on the level to tighten the knob, the bubble level in substantially at the center position.
The four sensor according to the corresponding positions of the wheels mounted to the fixture. To pay attention in the positioning of the sensor shaft to smear the dilute lubricating oil (butter), to prevent the plug for a long time after the positioning shaft wear and tear, cannot accurately installed in place that may affect the measurement accuracy. Connect the communication cable and the corner panel cable. Insert the arrow on the cable plug and the arrow on the socket. Four cables is the difference of different lengths, two 6.5 meters of cable is used to connect the sensor positioning system, and the two front wheels and two 4.5 meters of cable is connected with each other between the front and rear sensor. Each sensor has 3 sockets, the above two are exactly the same, the following one is used to connect the angle plate. When the cable is connected, the retaining pin is pulled off the corner plate and the back plate. Lock the vehicle would fall into a minimum lift stop position, to ensure the lifting platform in a horizontal state. Locator boot, sensor, power indicator light, press the R key or the position corresponding to the key activation of each sensor, the sensor placed on the level to tighten the knob, the bubble level in substantially at the center position.
- Pre：Auto lift machine manufacturer 2015/7/27
- Next：Auto lift machine manufacturer 2015/7/27
